Jeep Gladiator JT Heavy Duty Rear Track Bar Bracket - USA Made! The 67-6000 Heavy-Duty Series REAR TRACK BAR BRACKET is an important component for lifted JT Gladiator vehicles after lifting. This kit includes one (1) bolt-on ReadyLIFT Heavy-Duty Series track bar bracket and hardware. This Rear Track Bar Bracket helps to correct important suspension geometry both on and off road. The bracket aids in keeping the rear track bar aligned properly with the axle housing while also providing a super strong axle mounting point for when severely articulating the Jeep suspension in an off road or rock crawling environment.

(1) Heavy-duty fabricated steel rear track bar bracket with all necessary hardware.

WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov/product

SAEJ2492 WARNING: By installing this product, you acknowledge that the suspension of this vehicle has been modified. As a result, this vehicle may handle differently than factory-equipped vehicles. As with any vehicle, extreme care must be used to prevent loss of control or rollover during sharp turns or abrupt maneuvers. Always wear seat belts, and drive safely, recognizing that reduced speeds and specialized driving techniques may be required. Failure to drive this vehicle safely may result in serious injury or death. Do not drive this vehicle unless you are familiar with its unique handling characteristics and are confident of your ability to maintain control under all driving conditions. Some modifications (and combinations of modifications) are not recommended and may not be permitted in your state. Consult your owner's manual, the instructions accompanying this product, and state laws before undertaking these modifications. You are responsible for the legality and safety of the vehicle you modify using these components.